Current Balun / Current Choke / Choke Balun
----------------------------------------------------------
HB9ABX  update 3.Aug.04, 5.4.05, 16.4.05, 18.4.05, 14.6.05, ...  12.10.05-/ B2020



balun

This is a 50 Ohm 1:1 balun and serves perfectly to feed a symmetric antenna with a coax,
or to be inserted into a coax to prevent shield current and feedline radiation.

Insertion point is just at the antenna feed point.
.
Explanation: What is a current balun ?
   

Measurements of current baluns

 Broadband current balun 1,8-30 MHz: 

1.Version: for 100 Watt:                   -
Ferrite ring  FT140-43 with RG58
(or FT114-43
with coax RG174, ok for 100W)

1 ring is sufficient, by using 2, the efficiency on 1,8 MHz will increase
  you will need 2 rings for 200 W and RG 316.
With 2 rings, you place one over the other and make common windings through both.
In contrast to the picture:  make on the left and on the right side each 4.5 (or 5.5) turns!
(better is teflon coax RG316)
 

2. Version: for 1 Kilowatt:                 -
Ferrite ring FT240-43 with coax RG58

(better is teflon coax RG142)

Winding technique is important!
With coax from outside to the ferrite ring. Wind 4 1/2 turns on one
half of the ring, then through the ring to the other side and wind
again 4 1/2 turns.
The end of the winding should then be on the  opposite position
of the beginning of the winding. (See picture).
Then, fix the winding with PVC tape.


Static discharge
If the antenna has no connection to ground,
add a small 10 K resistor between center conductor
and braid of the coax to discharge static electricity.
This prevents "tac-tac" from statics.

Finally, place the balun into a weatherproof housing.
If the enclosure is metallic, make sure that the input ground
connection is not shorted to the output ground connection
by using isolated connectors.

This type of balun is more efficient than the W2DU design,
where a number of ferrite rings is pushed over the coax cable.
It is also the better choice than  winding the coax cable in a loop of several turns.


BACK